Siemens SENTRON PAC5200 Device Manual page 156

7 Operation at Use of a PC
7.3 Configuration of the Device
✧
Select the desired parameters in the list box according to Table 7-19.
✧
Change the passwords if necessary.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
7.3.6.4 Finish Configuration
The items in the Finish configuration menu in the navigation window are described in Device Configuration
Procedure, Device Configuration Procedure, in these subsections:
Activation: see Activating the Set of Parameters
Save configuration to file: see Save Configuration to File
Cancel: see Cancel
156 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015