Siemens SENTRON PAC5200 Device Manual page 137

To change the trigger management settings, proceed as follows:
✧
In the navigation window, select the Recording and Reporting menu and click Trigger management.
Figure 7-36
✧ Select the respective parameters in the list boxes according to Table 7-11.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Configure Tab, Trigger Management Input/Output Window
7 Operation at Use of a PC
7.3 Configuration of the Device
137