Siemens SENTRON PAC5200 Device Manual page 205

Submenu Display Number 32.5: Communication
Communication
Figure 8-22
NOTE
The MAC address is shown on the display but cannot be edited.
For this purpose, a prompt is displayed which you must acknowledge with OK.
Table 8-5
MAC address
1)
IP address
1)
Subnet
1)
Gateway
1)
After the communication parameters have been changed, the device restarts. For this purpose, a prompt
is displayed which you must acknowledge with OK.
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015

ENTER
32.5
ESC ESC OK
Submenu Display Number 32.5, Communication
IP Address Settings
Parameter
ESC OK
Change the para -
meters acc. to
following table
ENTER
39.0
IP Address
39.0
Communication
Ethernet
+
-
EDIT
Select. parameters
acc. to following table
Default Setting
fixed
192.168.0.55 Any
0.0.0.0 = DHCP
255.255.255.0 Any
192.168.0.1 Any
8 Operation at Use of the Display
8.4 Parameterization

39.0
IP-Addr.
Subnet
Gateway
ENTER
39.0
Bus protocol:
- Modbus TCP
- none

OK
Select .
bus protocol
Setting Range
EDIT
EDIT
+
205