Siemens SENTRON PAC5200 Device Manual page 223

Table 11-1
LED
RUN
H1
RUN
H1
RUN
H1
RUN
H1
RUN
H1
RUN
H1
RUN
H1
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Indications Signaled by LEDs on the Top Side of the Housing (cont.)
F4 softkey was pressed while switching on the supply voltage (calling default
ERROR
IP address).
H2
The boot program is started after the F4 softkey was pressed (calling the
ERROR
default IP address) during startup when switching on the supply voltage.
H2
The IP address was configured or received from DHCP.
DHCP active (H1 switches off after receiving the IP address via
DHCP)
ERROR
H2
The default IP address was confirmed by pressing the F4 softkey.
ERROR
H2
Boot loader started; no process application exists
ERROR
The IP address was configured or received from DHCP.
H2
DHCP active (LED H1 switches off after receiving the IP address via
DHCP)
ERROR
H2
The default IP address was confirmed by pressing the F4 softkey.
ERROR
H2
Meaning
Boot Loader
11 Failures and LED Indications
11.3 Indications Signaled by LEDs
223