Siemens SENTRON PAC5200 Device Manual page 146

7 Operation at Use of a PC
7.3 Configuration of the Device
NOTE
The factory settings are based on EN 50160. If you have changed the settings, the set parameters are applied
after a device restart. Resetting to the factory settings is possible.
To change the report configuration, proceed as follows:
✧
In the navigation window of the Recording and Reporting menu click Report configuration.
Figure 7-41
✧
Use the buttons to select the evaluation mode or enter the user-defined mode into the fields according to
Table 7-15.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
146
Configure Tab, Report Configuration Input/Output Window (Excerpt)
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015