Siemens SENTRON PAC5200 Device Manual page 222

11 Failures and LED Indications
11.3 Indications Signaled by LEDs
Meaning of the LEDs
C
C
NOTE
The designations and functions of the LEDs on the top side and on the display side of the housing are identical.
Therefore, only the LEDs on the top side of the housing are described in the following table.
NOTE
In the following table, the F4 softkey is pressed in order to call the default IP address. Devices without display
have the IP-Addr. push-button located on the DIN rail side, see Chapter 5.7.3, Figure 5-7.
Table 11-1
LED
RUN
H1
RUN
H1
222
LED (green, red, yellow): on
LED (green, red, yellow): flashes
LEDs H1/H2/ERROR: according to parameterization
LED: off
LED Speed (yellow):
off: 10 Mbit/s
on: 100 Mbit/s
LED Link/Activity (green):
LED on: Ethernet link is up
LED flashing: Ethernet link is up and data is transferred
LED off: no Ethernet partners connected
Indications Signaled by LEDs on the Top Side of the Housing
Device switched off
ERROR
H2
No firmware loaded
ERROR
H2
Meaning
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015