Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

9.4.2

Communication detail settings

Item
Set this item when change the transmission speed used for communication with the connected
Transmission Speed equipment.
(Default: 9600bps)
Set this item when change the data length used for communication with the connected equipment.
Data Bit
(Default: 8bits)
Set this item when change the data length used for communication with the connected equipment.
Stop Bit
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed during communication.
Parity
(Default: No)
Set the number of retries to be performed when a communication error occurs.
Retry
(Default: 0time)
Set the time period for a communication to time out.
Timeout Time
(Default: 3sec)
Set this item to adjust the transmission timing of the communication request from the GOT.
Delay Time
(Default: 0ms)
Select the communication format.
(Default: 1)
Format 1:
Format
Accessible to H-PCP-J, H-PCP-A, H-PCP-B, SRZ, FB, PF, HA, MA, RMC, SRX, B400AG, THV, FZ,
RZ series Format 2:
Accessible to CB series, RB, SA, SB1 series
9 - 50
9.4 GOT Side Settings
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠ GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description Range
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
0 to 5times
3 to 30sec
0 to 300ms
1/2