Device Range that Can Be Set
The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
■1. Setting item
The following shows the relation between station numbers of the temperature controller and the GOT data register.
Set the device name, device number, and bit number.
The bit number can be set only when specifying the bit of word device.
Displays the device type which is selected in [Device].(Bit/Word)
Set the monitor target of the set device.
To monitor the temperature controller of the specified station No.
1 to 119, 216 to 255 : To monitor the temperature controller of the specified station No.
200 to 215: To specify the station No. of the temperature controller to be monitored by the value of GOT
data register (GD).
The device setting of FUJI temperature controller
Devices are set with the coil and register numbers of the temperature controller.
For parameters (such as an address map of coil/register number and a parameter)
corresponding to each number, refer to the manual of the temperature controller to be used.
GOT data register (GD)
(If setting a value outside the range
above, a device range error occurs.)
5.6 Device Range that Can Be Set
1 to 255
5 - 33