Connecting To Stardom - Mitsubishi Electric GOT2000 Series Connection Manual

7.2.11

Connecting to STARDOM

Make the communication settings as shown below.For details of the communication settings, refer to the following manual.
➠
■1. COM port setting
Make the settings on the FCX Maintenance Page for STARDOM.
Step 1.
Select [Reboot (Maintenance Mode)] on the Reboot screen of the FCX Maintenance Page to set the
maintenance mode.
Step 2.
Set the COM1 port driver to be used.Execute [JEROS Basic Setting File] from the [Edit System Setting File]
screen on the FCX Maintenance Page.
Confirm that the line of [Com1SioDriver] is as follows.
Com1SioDriver=DUONUS_SIO
Step 3.
Set the COM1 port to be used.Execute [COM1 Port Setting File] from the [Edit System Setting Files] screen
on the FCX Maintenance Page.Make the settings as follows according to the communication specifications
on the setting screen.
Leave the settings as default if not listed on the communication setting items.
(Communication setting items) ( ) in the table shows the names on the FCX Maintenance Page.
Transmission speed (Baudrate)
Data length (DataBitLength)
Stop bit (StopBitLength)
*1
Parity bit (Parity)
Baudrate
DataBitLength
StopBitLength
Parity
FifoMode
InitialDTRState
SendFlowControlMode
ReceiveFlowControlMode
*1
Step 4.
Select "Reboot (Online Mode)" on the "Reboot" screen of the FCX Maintenance Page to set the online
mode.
7 - 20
7.2 Serial Connection
Peripheral Software Manual for YOKOGAWA PLC
POINT POINT POINT
Connection between STARDOM and the PC for communication settings
For the communication settings of STARDOM, STARDOM and the PC for communication
settings must be connected to Ethernet using the Resource Configurator (peripheral software).
Item
*1
*1
*1
= *1
= *1
= *1
= *1
= YES
= ON
= CTS
= DTR
Adjust the settings with GOT communication settings.
➠
7.2.5 ■2. Communication detail settings
Set value
4800bps, 9600bps,
19200bps, 38400bps,
57600bps, 115200bps
8bits, 7bits
1bit, 2bits
none/odd/even