Mitsubishi Electric GOT2000 Series Connection Manual page 396

(3) AB Control/CompactLogix
Item
Transmission Speed
Data Bit
Stop Bit
Parity
Sum Check Type
Retry
Timeout Time
Adapter Address
Host Address
Delay Time
10 - 16
10.2 Serial Connection
Set this item when change the transmission speed used for
communication with the connected equipment.
(Default: 19200bps)
Set this item when change the data length used for communication with
the connected equipment.
(Default: 8bits)
Specify the stop bit length for communications.
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed
during communication.
(Default: None)
Specify the format in which the sum check is performed during
communication when performing sum check.
(Default: BCC)
Set the number of retries to be performed when a communication error
occurs.
(Default: 3times)
Set the time period for a communication to time out.
(Default: 3sec)
Specify the adapter address (station No. of the PLC that the GOT will
monitor) in the connected network.
(Default: 0)
Specify the host address (station No. of the adapter to which the GOT is
connected) in the connected network.
(Default: 0)
Set this item to adjust the transmission timing of the communication
request from the GOT.
(Default: 0ms)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description Range
9600bps,
19200bps,
38400bps,
57600bps
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
BCC,
CRC16
0 to 5times
3 to 30sec
0 to 254
0 to 254
0 to 300ms