Finisher Bin Media Present Error Service Check - Lexmark MX81 Series Service Manual

Action
Step 5
Check the compactor:
•
for proper installation
•
for damage and contamination
•
for cable damage
Is the above component ok?
Step 6
Remove the stapler carriage. Manually turn the gears to open the stapling
mechanism. While open, check the area under the stapling mechanism
and make sure it is free from obstructions.
Is it free of damage?
Step 7
Reseat all connectors on the controller PCBA.
Does the error remain?

Finisher bin media present error service check

Action
Step 1
Check the auto connector end of the printer below the staple finisher.
Is it free of damage?
Step 2
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Stapler/offset stacker lower interface cable
removal" on page 611.
Reseat the cable (J15) on the controller PCBA, then POR the machine.
Does the error remain?
Yes
Go to step 6.
Go to step 7.
Replace the controller
PCBA. Go to
offset stacker
controller PCBA
removal" on page
613.
If the error persists,
then replace the staple
finisher. Go to
finisher/offset stacker
option removal" on
page
Yes
Go to step 2.
Go to step 3.
Diagnostic information
226
No
Replace the sensor
(compactor HP).
Replace the stapler
carriage assembly. Go
to "Stapler carriage
assembly removal" on
page 620.
The problem is solved.
"Stapler/
"Staple
595.
No
Replace the upper
interface cable of the
printer under the
staple finisher.
The problem is solved.
7463