Entering Recovery Mode; Accessing The Network Se Menu; Service Engineer Menu; Accessing The Service Engineer (Se) Menu - Lexmark MX81 Series Service Manual

Entering recovery mode

This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC by USB.
1
Turn off the printer.
2
Press and hold the 7, 2, and 8 buttons simultaneously.
3
Turn on the printer.
4
Release the buttons after 10 seconds.

Accessing the Network SE menu

This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1
Navigate to:
Networks/Ports > Standard Network > Std Network Setup.
2
Press and hold the 6, 7, and 9 simultaneously.

Service Engineer menu

•
"Accessing the service engineer (SE) menu" on page 265
•
"Service engineer (SE) menu" on page 265

Accessing the service engineer (SE) menu

From a Web browser on a host PC, add /se to the printer IP address.

Service engineer (SE) menu

This menu should be used as directed by the next level of support.
Top‑level menu Intermediate menu
Print SE Menus
General Copyright — Displays copyright information
Code
History
• Network code level — Displays network code level
•
Network Compile Info — Displays network compile information
•
Printer Code Level — Displays printer code information
•
Printer Compile Info — Displays compile information
•
Print History
•
Mark History
•
History Mode
Service menus
265
7463