8
Remove the two screws (D) securing the limit switch.
9
Disconnect the cable (J7) from the controller PCBA.
10
Route the cable off the stapler, and remove the stapler door close limit switch.
Note: Pay attention to the original routing of the cables.
Mailbox option removals
•
"Mailbox assembly removal" on page 624
•
"Mailbox top cover removal" on page 624
•
"Mailbox rear door removal" on page 624
•
"Mailbox right cover removal" on page 626
•
"Mailbox spring with string removal" on page 627
•
"Mailbox solenoid removal" on page 628
•
"Mailbox left cover removal" on page 630
•
"Mailbox controller PCBA removal" on page 631
•
"Sensor (mailbox divert motor) removal" on page 633
•
"Mailbox lower interface cable removal" on page 634
•
"Mailbox upper interface cable removal" on page 636
•
"Mailbox divert motor removal" on page 636
•
"Mailbox media bin full flag removal" on page 638
Repair information
623
7463