Hcit Top Cover Assembly Removal - Lexmark MX81 Series Service Manual

4
Remove the controller PCBA.
Installation note: Make sure the controller PCBA is properly mounted by aligning the pins (B).

HCIT top cover assembly removal

Note: This is not a FRU.
1
Remove the drawer assembly rear cover. See
2
Remove the drawer assembly left cover. See
3
Disconnect all cables from the controller PCBA.
Note: Pay attention to the original routing of the cables. Make sure that the cables don't interfere with the
drawer's moving parts. Use cable ties to keep the cables organized.
"HCIT drawer assembly rear cover removal" on page
"HCIT drawer assembly left cover removal" on page
Repair information
548
7463
542.
543.