Sensor (Media In Stapler) Jam Service Check - Lexmark MX81 Series Service Manual

Action
Step 7
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?

Sensor (media in stapler) jam service check

Action
Step 1
Check the auto connector end of the stapler below the staple finisher.
Is it free of damage?
Step 2
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Stapler/offset stacker lower interface cable
removal" on page 611.
Remove the left cover. Reseat the cable (J15) on the controller PCBA, then
POR the machine.
Does the error remain?
Step 3
Check the sensor flag (media in stapler):
•
for damage
•
if it moves freely when manually actuated
Is the above component ok?
Yes
Replace the controller
PCBA. Go to
offset stacker
controller PCBA
removal" on page
613.
If the error persists,
then replace the staple
finisher. Go to
finisher/offset stacker
option removal" on
page
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Diagnostic information
201
No
The problem is solved.
"Stapler/
"Staple
595.
No
Replace the upper
interface cable of the
stapler under the
staple finisher.
The problem is solved.
Replace the staple
finisher assembly. Go
to "Staple finisher/
offset stacker option
removal" on page
595.
7463