Post (Power-On Self Test)-Output Bin Cable Not Connected Error Service Check - Lexmark C734 Service Manual

5026
920.17—POST (power-on self test)—Output bin cable not connected error service
check
Step Questions / actions
1 Turn the printer off, and then remove the rear
frame cover. See
removal" on page
Reseat the bin full sensor cable in connector
JBIN1 (A).
A
Does the error clear?
2 Check the bin full sensor cable in connector
JBIN1 for pinch points and any other damage
to the cable or connector.
Is the cable damaged?
3 1. Disconnect the cable in the JBIN1
connector.
2. Connect the new bin full flag cable in the
JBIN connector.
3. Bring the printer up in Diagnostic menu
(turn off the printer, press and hold
. and turn on the printer).
4. Select SENSOR TESTS, and press
Select (
5. Select Other Sensors, and press
Select (
6. Select Bin Full Test, and press
Select (
7. Activate the new bin full sensor by placing
a sheet of paper in the sensor.
Did the bin full sensor change from Open to
Closed?
2-106
Service Manual
"Rear frame cover
4-33.
1 JBIN1 1 1 JFUSER1 1 JHVPS1 1 JBLW1
JSB1 1 JFAN1 JBOR1 1 JMIRR1 1
1
JCVR1
F5
F6
JLVPS2
1
JCARTP1 F7
1 J49
JCARTS1
1
JDIMM1
F9
JCARTS2
1
JTLBT1
JCARTP2 1 1
1
1 JTWF1
F10
JTDBUG1
1 JDVR1 1
JTPS1
1
J5
JOPT1
1 JDX1 1
1 F13
1 JFDS1
F12
JINT1 F14
1
JFDPCK1 JTRAY1 JSEC1 JPH1
1 1 JT12
).
).
).
Yes
Problem resolved.
1
JOPP1
JT1
1
JBOOT1
JUSB1
1
J10
JFMUSB1
Replace the bin full sensor
with cable. See "Bin full
sensor removal" on
page 4-49.
Replace the bin full sensor
and cable. See "Bin full
sensor removal" on
page 4-49.
and
No
Go to step 2.
Go to step 3.
Replace the system board.
See "System board
removal" on page 4-139.