Finisher Side Door Error Service Check - Lexmark MX81 Series Service Manual

Action
Step 8
Replace the tray.
Does the error remain?
Step 9
Replace the drawer.
Does the error remain?

Finisher side door error service check

Action
Step 1
Check the auto connector end of the printer below the staple finisher.
Is it free of damage?
Step 2
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Stapler/offset stacker lower interface cable
removal" on page 611.
Remove the left cover. Reseat the cable (J15) on the controller PCBA, then
POR the machine.
Does the error remain?
Step 3
Check if the stapler cartridge access door closes properly. Make sure that
obstructions are cleared and that the access door is correctly installed.
Is the above component functioning properly?
Step 4
Check the sensor (cartridge door interlock). Enter Diagnostics Menu and
navigate to:
FINISHER TESTS > Sensor Test >Cover and Door
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Step 5
Remove the left cover. Reseat the cable (J20) on the controller PCBA then
POR the machine.
Does the error remain?
Yes
Go to step 9.
Contact the next level
of support.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 8.
Go to step 6.
Diagnostic information
218
7463
No
The problem is solved.
The problem is solved.
No
Replace the upper
interface cable of the
printer under the
staple finisher.
The problem is solved.
Replace the stapler
cartridge access door.
Go to "Stapler
cartridge access door
removal" on page
619.
Go to step 5.
The problem is solved.