Sensor (Drawer Pass Through) Removal - Lexmark MX81 Series Service Manual

4
Remove the two screws (A) using a #1 Phillips screwdriver.
5
Route the cable off the drawer, then remove the lift plate drive motor.

Sensor (drawer pass through) removal

1
Remove the media tray. See
2
Remove the rear cover. See
3
Remove the left cover. See
4
Disconnect and release the cables (J4, J8 and J7) from the controller PCBA.
Note: Pay attention to the original position of the cables.
"550-sheet media tray and drawer assembly removal" on page
"Drawer assembly rear cover removal" on page
"Drawer assembly left cover removal" on page
Repair information
570
560.
562.
563.
7463