Drawer Media Feeder Removal - Lexmark MX81 Series Service Manual

5
Push the tabs inward, then push the connector off its slot.
6
Route the interface cable off the drawer, and remove.
Note: Pay attention to the original routing of the cable.

Drawer media feeder removal

1
Remove the drawer assembly rear cover. See
2
Remove the drawer assembly left cover. See
3
Disconnect the three media feeder cables (J11, J4 and J7) from the controller PCBA.
"Drawer assembly rear cover removal" on page
"Drawer assembly left cover removal" on page
Repair information
567
7463
562.
563.