Sensor (Adf Media Exit) Never Arriving Or Late Arriving Jam Service Check - Lexmark MX81 Series Service Manual

Action
Step 3
Check the sensor (ADF media exit) for proper connection.
Is the above component properly connected?
Step 4
Place an undamaged document in the ADF, and perform a ADF test.
Does the error remain?
Step 5
Perform a print test using the ADF.
Does the problem remain?

Sensor (ADF media exit) never arriving or late arriving jam service check

Action
Step 1
Check the original document condition.
Is the original document free of paper clips and staples as well as damage
such as creases, tears, holes or excessive wear?
Step 2
Check the media path for contaminates.
Is the media path free of excess media dust and foreign objects such as
paper clips and staples?
Step 3
Check the sensor (ADF media exit) for proper operation.
a
Enter the Diagnostics Menu.
b
Touch SCANNER TESTS.
c
Touch Sensor Tests.
d
Observe the line "sensor (ADF media exit)."
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Step 4
Check the sensor (ADF media exit) for proper connection.
Is the above component properly connected?
Yes
Replace the sensor
(ADF media exit). Go to
"Interrupt with flag
sensor (ADF media
exit) removal" on
page
Replace the ADF
controller PCBA.
Contact the next
highest level of
support.
Yes
Go to step 2.
Go to step 3.
Go to
Replace the sensor
(ADF media exit). Go to
"Interrupt with flag
sensor (ADF media
exit) removal" on
page
Diagnostic information
130
No
Replace the
connection.
487.
Problem solved.
Problem solved.
No
Remove damaged
original document and
replace with a new
undamaged original
document. Perform an
ADF test. If the problem
remains, go to
Remove all
contaminates from the
media path.
step 5. Go to step 4.
Replace the
connection.
487.
7463
step 2.