8
Remove the sensor cover.
9
Remove the upper redrive. See
10
Remove the sensor (standard bin full) with actuator. See
11
Remove the standard bin cover. See
12
Disconnect and remove the two cables that are attached to the cartridge door from the controller board.
13
Remove the e‑clip (B) securing the pin to the hinge.
14
Remove the pin (C).
15
Raise the control panel to its uppermost position.
"Upper redrive removal" on page
"Standard bin cover removal (MX81x)" on page
Repair information
354
363.
"Sensor (standard bin full) removal" on page
7463
356.
359.