4Xx Error Messages (400-499.99) - Lexmark MX81 Series Service Manual

4xx error messages (400‑499.99)
Error code Description
400.XX Invalid parameters during output option paper jam
431.01 Media remains detected by the output option
1/mailbox sensor (pass through) after power on.
431.03 The media fed did not reach the output option
1/mailbox sensor (pass through).
431.05 The media while feeding remains detected by the
output option 1/mailbox sensor (pass through).
431.09 Never received Page In Output from output option
1/mailbox
431.10 Invalid Page ID returned by output option 1/mailbox
431.41 Output option 1/mailbox main/interface motor
stalled
431.42 Output option 1/mailbox main/interface motor did
not reach the required speed.
431.43 Took too long to ramp up main/interface motor in
output option 1/mailbox
431.53 Output option 1/mailbox main/interface motor did
not reach the required speed.
431.71 Diverter failed to leave its home position on the
output option 1/mailbox
431.72 Diverter failed to reach its home position on the
output option 1/mailbox
436.01 Media remains detected by the output option
2/mailbox sensor (pass through) after power on.
436.03 The media fed did not reach the output option
2/mailbox sensor (pass through).
436.05 The media while feeding remains detected by the
output option 2/mailbox sensor (pass through).
436.09 Never received Page In Output from output option
2/mailbox
436.10 Invalid Page ID returned by output option 2/mailbox
Action
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Close the rear door properly.
If the problem remains, then go to
pass through) jam service check" on page
1
POR the machine.
2
Reseat the output option on the printer.
3
Open the rear door and clear obstructions along
the paper path.
If the problem remains, then go to
service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Close the rear door properly.
If the problem remains, then go to
pass through) jam service check" on page
Diagnostic information
183
7463
"Sensor (mailbox
188.
"Mailbox failure
163.
"Mailbox diverter
190.
"Sensor (mailbox
188.