Drawer Lower Interface Cable Removal - Lexmark MX81 Series Service Manual

5
Crimp both connector studs (A) using a pliers to make them fit to the holes. Push the connector off its slot.
6
Route the upper interface cable off the drawer, and remove.
Note: Pay attention to the original routing of the cable.

Drawer lower interface cable removal

1
Remove the drawer assembly rear cover. See
2
Remove the drawer assembly left cover. See
3
Remove the drawer controller PCBA. See
4
Remove the controller PCBA shield.
"Drawer assembly rear cover removal" on page
"Drawer assembly left cover removal" on page
"Drawer controller PCBA removal" on page
Repair information
527
7463
523.
524.
525.