Slide Wall Assembly - KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual

Step 4: Slide Wall Assembly
A: Place (041) Narrow Back Panel against the left side of (040) Slide End Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(041) Narrow Back Panel to (040) Slide End Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 4.1 and 4.2)
B: Place (042) Narrow Front Panel against the right side of (040) Slide End Panel noticing panel orientation.
The tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(040) Slide End Panel to (042) Narrow Front Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 4.1 and 4.3)
Fig. 4.2
Flush
041
Notice (041) Narrow
Back Panel overlaps
(040) Slide End Panel
Wood Parts
1 x Slide End Panel 1-1/4 x 37 x 92"
040
1 x Narrow Back Panel 1-1/4 x 21-1/2 x 92"
041
1 x Narrow Front Panel 1-1/4 x 21-1/2 x 92"
042
040
WL5
Fig. 4.1
Flush
Hardware
8 x 1/4 x 2-1/2" Wafer Lag
WL5
24
Fig. 4.3
042
040
Flush
040
Notice (040) Slide End
Panel overlaps (042)
Narrow Front Panel
WL5