Attach Steel Hand Grips To Fort - KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual

Step 11: Attach Steel Hand Grips to Fort
A: Measure 6" from the top of (025) RW/AL Support on (052) Back Wall Panel in the 2 places shown below,
pre-drill with a 1/8" drill bit then attach 2 Steel Hand Grips with 2 (WL3) 1/4 x 1-3/8" Wafer Lag (with flat
washer) per Steel Hand Grip. (fig. 11.1 and 11.2)
Steel Hand Grip
6"
Fig. 11.1
025
Steel
Hand
Grip
1/4" Flat
Washer
Hardware
4 x 1/4 x 1-3/8" Wafer Lag
WL3
(1/4" flat washer)
38
052
6"
052
Other Parts
2 x Steel Hand Grip
Fig. 11.2
1/4" Flat
Washer
WL3
WL3