Table of Contents
Advertisement
Step 2: Rock Wall Assembly
Fig. 2.1
1779
S2
A: Lay 2 (0349) Rock Rails down, side by side with angled edges facing down. (fig. 2.1)
B: Place (1779) CE Access Board on the bottom of each (0349) Rock Rail as shown in fig. 2.1. Make sure (1779)
CE Access Board is flush to the outside and bottom edges of each (0349). Attach using 4 (S2) #8 x 1-1/2" Wood
Screws.
C: 7-3/4" down from the top of both (0349) Rock Rails place 1 (1777) CE Rock Board B, making sure the sides are
flush to the outside edges of each (0349) Rock Rail. Attach using 4 (S2) #8 x 1-1/2" Wood Screws. (fig. 2.1)
D: In between the (1779) CE Access Board and (1777) CE Rock Board B stagger 2 (1777) and 2 (1778) CE
Rock Boards A and B using 4 (S2) #8 x 1-1/2" Wood Screws per board. Placing them as shown in fig. 2.1, this
will prevent rocks from forming a straight line. Make sure the boards are evenly spaced and do not exceed 2-3/8"
between boards.
Fig. 2.2
Fig. 2.3
PB2
S10
Rock
Wood Parts
1 x
CE Access Board 1 x 6 x 17"
1779
2 x
CE Rock Board A 1 x 6 x 17"
1778
3 x
CE Rock Board B 1 x 6 x 17"
1777
2 x
Rock Rail 2 x 3 x 51"
0349
1778
1777
1/4" Lock
Washer
3/16" Flat
Washer
1/4" Barrel
Nut
24 x
5 x
5 x
1778
1777
Note: Gaps between boards 2-1/4",
not to exceed 2-3/8"
E: Place 1 rock on each (1777) and (1778) CE Rock Board
A and B (fig. 2.2) and attach using 1 (PB2) 1/4 x 1-1/4" Pan
Bolt (with lock washer, flat washer and barrel nut) and 1 (S10)
#8 x 1" Pan Screw per rock. The Screw must be in the hole
directly under the Pan Bolt, it will stop the rock from spinning.
(fig. 2.3)
Hardware
#8 x 1-1/2" Wood Screw
S2
#8 x 1" Pan Screw
S10
1/4 x 1-1/4 Pan Bolt
PB2
(1/4" lock washer, 3/16" flat washer & 1/4" barrel nut)
17
Note: The holes
in the rock boards
1777
must orient to the
0349
top of the boards.
7-3/4"
Approx
Other Parts
5 x Rocks (3 green/2 yellow)
Hide quick links:
Advertisement
Table of Contents
