Slide Section Assemblies - KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual

Step 24: Slide Section Assemblies
Part 1
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the
round recess and the lock nuts go through the side with the hexagonal recess. (fig. 24.3)
A: Fit 2 TNR2 Slide Elbows together and attach with 8 (PB1) 1/4 x 3/4" Pan Bolts (with lock nut) as shown in
fig. 24.1. It is very important to attach bolts as indicated.
B: Repeat Step A 3 more times to create 4 Elbow Sections in total.
C: Attach TNR2 Slide RT Flange and TNR2 Slide LT Flange together using 4 (PB1) 1/4 x 3/4" Pan Bolts (with
lock nut) as shown in fig. 24.2. This creates the Flange Assembly.
Fig. 24.1
Lock
Nut
PB1
Lock
Nut
Use a 7/16" open end
wrench for nuts
TNR2
Slide
Elbow
TNR2
Slide
Elbow
Fig. 24.3
PB1
36 x
For a Helpful Hints video on
assembling this tube slide
please visit http://bit.ly/2ACggzj
Flange
Fig. 24.2
Assembly
TNR2
Slide LT
Flange
PB1
TNR2
Slide RT
Flange
Hardware
1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
66
Lock
Nut
PB1
Lock
Nut
Other Parts
1 x TNR2 Slide LT Flange
1 x TNR2 Slide RT Flange
8 x TNR2 Slide Elbow