Attach Transom Assembly - KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual

Step 44: Attach Transom Assembly
Part 1
A: Place 1 Transom Assembly on both (051) Front Wall Panel and (052) Back Wall Panel so they are tight
to (410) Swing Top and (420) Wall Supports. From the outside attach each Transom Assembly to (420) Wall
Supports with 2 (S3) #8 x 2-1/2" Wood Screws per assembly. (fig. 44.1)
B: From the inside attach (420) Wall Supports to each Transom Assembly and both (051) Front Wall Panel and
(052) Back Wall Panel with 4 (S3) #8 x 2-1/2" Wood Screws per support. (fig. 44.2)
C: From the inside attach each (404) Wall Tie to both (051) Front Wall Panel and (052) Back Wall Panel with 2
(S11) #8 x 2" Wood Screws per board. (fig. 44.2)
Fig. 44.1
Transom
Assembly
051
420
052
Transom
Assembly
x 2 per Transom
S3
Assembly
420
052
Hardware
12 x #8 x 2-1/2" Wood Screw
S3
4 x #8 x 2" Wood Screw
S11
93
420
(both
S3
supports)
S11
051
Fig. 44.2
404
Transom
Assembly