Attach Diagonals - KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual

Step 9: Attach Diagonals
Part 1
A: Loosely attach (090) SW Ground to (091) Diagonal with 1 (WB9) 5/16 x 2-1/8" Wafer Bolt (with flat washer
and t-nut) then place (091) Diagonal tight and flush to the front of (040) Slide End Panel. (090) SW Ground to be
flush to the bottom of (040) Slide End Panel. (fig. 9.1 and 9.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach (091) Diagonal to (040) Slide End Panel with 1 (WL5) 1/4 x
2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 9.1 and 9.2)
C: Making sure bottom of (090) SW Ground is flush to bottom of (040) Slide End Panel then attach with 2 (S11)
#8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw then tighten the bolt. (fig. 9.1 and 9.2)
Fig. 9.1
040
Wood Parts
1 x SW Ground 5/4 x 4 x 14-1/4"
090
1 x Diagonal 1-1/4 x 3 x 22"
091
040
Flush
Hardware
WB9
1 x 5/16 x 2-1/8" Wafer Bolt (5/16" flat washer, 5/16" t-nut)
1 x 1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x #8 x 3" Wood Screw
S4
2 x #8 x 2" Wood Screw
S11
33
S11
S4
Flush
090
Fig. 9.2
5/16" Flat
WL5
Washer
091
5/16"
T-Nut
5/16" Flat
Washer
WB9