KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual page 34

Step 9: Attach Diagonals
Part 2
D: Loosely attach (092) Support Diagonal to (093) Diagonal with 1 (WB9) 5/16 x 2-1/8" Wafer Bolt (with flat
washer and t-nut) then place (093) Diagonal tight and flush to the front of (050) SW Wall Panel. (092) Support
Diagonal to be flush to the bottom of (050) SW Wall Panel. (fig. 9.3 and 9.4)
E: Pre-drill pilot hole with a 3/16" drill bit then attach (093) Diagonal to (050) SW Wall Panel with 1 (WL5) 1/4 x
2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 9.3 and 9.4)
F: Making sure bottom of (092) Support Diagonal is flush to bottom of (050) SW Wall Panel then attach with 2
(S11) #8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw then tighten the bolt. (fig. 9.3 and 9.4)
Fig. 9.3
Wood Parts
1 x Support Diagonal 5/4 x 4 x 24-1/2"
092
1 x Diagonal 2 x 3 x 42-1/4"
093
050
093
5/16"
T-Nut
5/16" Flat
Washer
Hardware
WB9
1 x 5/16 x 2-1/8" Wafer Bolt (5/16" flat washer, 5/16" t-nut)
1 x 1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x #8 x 3" Wood Screw
S4
2 x #8 x 2" Wood Screw
S11
34
5/16" Flat
Washer
WL5
S4
WB9
092
Fig. 9.4
Flush
050
S11
Flush