Figure 6-3. System Configuration Menu; System Config; Primary Timing Source; Backup Timing Source - ADTRAN Atlas 550 User Manual

Chapter 6. System Control Terminal Menus
C P R
HAIN ORT X
B
YTES
C P
HAIN ORT
O E
VERRUN RRS
C P
HAIN ORT
F E
RAMING RRS
C C P
LEAR HAIN ORT
C
OUNTRS
S C
YSTEM ONFIG
P T
RIMARY IMING
S
OURCE
B T
ACKUP IMING
S
OURCE
ADLP A
DDRESS
6-8
Read security: 5
Displays the number of received data bytes.
Read security: 5
Displays the number of overrun errors.
Read security: 5
Displays the number of received framing errors.
Clears all chain port counters. Press Y to activate this command.
The S C menu allows you to set up the ATLAS 550 operational
YSTEM ONFIG
configuration. Figure 6-3 shows the items included in this menu.
Write security: 3; Read security: 5
Selects the primary timing source. Select
either or a port from one of the
INTERNAL
installed modules.
Write security: 3; Read security: 5
Selects the secondary timing source. You can select either
port from one of the installed modules. ATLAS 550 uses the backup timing
source if the primary timing source goes into alarm. The B
S should be different from the P
OURCE
Write security: 2; Read security: 5
Shows the system ADTRAN Data Link Layer Protocol (ADLP) address for
connecting remote devices to management software. The allowable range is
between 2 and 65520. Enter a value not used by any other ADTRAN units
controlled by the management software.
ATLAS 550 User Manual

Figure 6-3. System Configuration Menu

T S
RIMARY IMING OURCE
or a
INTERNAL
T
ACKUP IMING
.
61200305L1-1