[Pr. Pc10_Analog Monitor 2 Output (Mod2)]; [Pr. Pc11_Analog Monitor 1 Offset (Mo1)]; [Pr. Pc12_Analog Monitor 2 Offset (Mo2)]; [Pr. Pc16_Function Selection C-3A (*Cop3A)] - Mitsubishi Electric MELSERVO-J5 MR-J5-G Series User Manual

[Pr. PC09.3_Analog monitor 1 output axis selection]
Initial value
0h
0: A-axis
1: B-axis
2: C-axis

[Pr. PC10_Analog monitor 2 output (MOD2)]

Initial value
00000001h
[Pr. PC10.0-1_Analog monitor 2 output selection]
Initial value
01h
Select the signal to be outputted to analog monitor 2.
Refer to the following for setting values.
Page 57 [Pr. PC09_Analog monitor 1 output (MOD1)]
[Pr. PC10.3_Analog monitor 2 output axis selection]
Initial value
0h
Refer to [Pr. PC09 Analog monitor 1 output] for the setting value.

[Pr. PC11_Analog monitor 1 offset (MO1)]

Initial value
0 [mV]
Set the offset voltage of MO1 (Analog monitor 1).

[Pr. PC12_Analog monitor 2 offset (MO2)]

Initial value
0 [mV]
Set the offset voltage of MO2 (Analog monitor 2).

[Pr. PC16_Function selection C-3A (*COP3A)]

Initial value
00000000h
[Pr. PC16.4_Servo motor incorrect wiring detection function selection]
Initial value
0h
Select enabled/disabled of the servo motor incorrect wiring detection function.
0: Servo motor incorrect wiring detection disabled
1: Servo motor incorrect wiring detection enabled
1 DETAILED LISTS OF SERVO PARAMETERS
58
1.4 Extension setting servo parameters group ([Pr. PC_ _ ])
Setting range
0h to 2h
Setting range
00000000h to 0000041Fh
Setting range
00h to 1Fh
Setting range
0h to 2h
Setting range
-999 to 999
Setting range
-999 to 999
Setting range
00000000h to 21000000h
Setting range
0h to 1h
Supported software version
A0
Setting method
Common
Supported software version
A0
Supported software version
A0
Setting method
Common
Setting method
Common
Setting method
Each axis
Supported software version
A0
Supported software version
Refer to each detail No.
Supported software version
A0
Supported software version
A0
Supported software version
Refer to each detail No.