AGFA CR Series Service Manual page 97

DD+DIS155.11E
# Comment
1 Approx. 1 second after switch on the status LED starts red blinking.
2 After boot-up of the PMI board (approx. 17 seconds after switch on), until
sending the self-test signal (approx. 40 seconds after switch on), the digitizer
performs following actions:
3 Send self test signal to all SW modules means: Check whether all consumers
are connected. Click sounds of motors are audible. The galvo starts up.
4 When the self test starts, message "Digitizer start-up" is displayed in the Error
Viewer.
This message is generated by the digitizer and will not be displayed however,
if the error viewer is not started-up yet. This is the case for example if digitizer
and workstation are switched on simultaneously.
5 During the IP Clean-up cycle, the drawer motors is briefly audible.
6 If the NX viewer is not running following message appears in the Error Viewer:
"Image processing software is not available. Restart the image processing
software". The check whether the NX application is running is repeated each
three seconds, even after successful connection.
Exception: After a scan cycle, when the cassette is waiting to be removed by
the customer, the digitizer does not check, whether the NX application is
running.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013

The internal logging and error messages are loaded.

The data in the E-labels are compared with the E-label data on the USB
flash drive.
The status LED stays red blinking. No audible actions. No message in the
Error Viewer.
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 2 / Page 13 of 19
Type 5151 / 100 / 110 / 200 / 210
Functional Description
Agfa Company Confidential