AGFA CR Series Service Manual page 160

DD+DIS155.11E
# Setting on Digitizer
1 Destination IP Address
2 Destination Name
3 AE title (Image)
4 Digitizer IP Address
5 Digitizer AE title
6 Digitizer Hostname
7 Digitizer Type "CR 10-X"
or "CR 12-X"
Digitizer IP address or subnet mask configured wrong (e.g. due to a typing error):
Cause 5
Accessing the digitizer service pages is not possible anymore, as the network settings
are unknown.
Reset the IP address to default. Proceeding:
Solution 5
(1) Switch off the digitizer.
(2) Remove the USB flash drive and insert it at the Service PC.
(3) Go to folder \ARC_1103 (or higher version) on the USB flash drive.
(4) Double click on: <RestoreDefaultAddress.cmd>
 A Command Line Window opens for a short time.
 The file startup.com is written to the root of the USB flash drive.
(5) Release the USB flash drive from the Service PC and re-insert it at the digitizer.
(6) Switch on the digitizer.
(7) Wait until the boot-up is finished (approximately 1 minute).
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2013
Setting on NX (correspondent parameter)
NX Workstation IP address (Windows setting)
NX Workstation "Processing Station Name"
(Configuration Tool menu "General Configuration 
Configure Workstation settings  General Settings")
NX Workstation "Performed Station AE Title"
(Configuration Tool menu "General Configuration 
Configure Workstation settings  General Settings")
IP address in digitizer device configuration. As
alternative also the digitizer host name can be used.
AE title in digitizer device configuration.
Host Name in digitizer device configuration. As
alternative also the digitizer IP address can be used.
Has to be selected when adding a new digitizer with
the NX Configuration Tool. Is later on displayed as
"Type" in the Device Configuration Settings.
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Troubleshooting
Chapter 3.3 / 12 of 46
Agfa Company Confidential