DD+DIS155.11E
(7)
Insert the digitizer USB flash drive
into the USB Port of the NX
Workstation.
(8)
Go to NX configurator screen:
Devices Digitizer
Configuration
Digitizer.
(9)
Click on <Create CPF> and save
the file on the USB flash drive root
folder.
(10) Activate the configuration via
menu: File Activate
Configuration
(11) Navigate to directory \ARC_1404
(or higher version) on the USB
flash drive.
(12) Double-click file
InstallCPF.cmd
(13) Press any key to continue.
(14) Release the USB flash drive from
the NX Workstation and insert it at
the digitizer.
(15) Switch on the digitizer: The
digitizer boots-up and resets
automatically after approx.
3 minutes.
(16) Wait until the 2nd boot-up is
finished.
(17) Connect NX workstation and
digitizer to the local network.
(18) Switch on the digitizer.
(19) Enter the new digitizer IP address
in the browser address window.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Figure 11
Figure 12
Figure 13
Chapter 1 / Page 16 of 47
Agfa Company Confidential
515101ha.cdr