AGFA CR Series Service Manual page 131

DD+DIS155.11E
2.4.3 Destination Settings
The menu "Destination Settings" allows entering data to modify the destination network
Purpose
settings.
(1) Select service menu:
Usage
<Destination Settings>.
Perform the required settings. See
also NOTE below.
(2) Select <Load Destination
Network Data from USB> to
read out the data from an adc.cpf
file on the digitizer USB flash drive.
This CPF file:


(3) If you want to go back to the
default destination settings: Select
<Load default settings>.
(4) Select <Test Communication>
to check the network connection to
the NX workstation.
*The CCM tool (Configuration and Customization Manager) is by default installed on the NX workstation.
NOTE:

The configuration of the digitizer settings is described in the digitizer Service
Manual, chapter 1, Controls, Connections and Setup Procedures.

Function "Load default settings" is available as of software version ARC_1404
only.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
Can be created with the CCM
tool* or
Can be exported from the NX
configuration tool.
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced ReaderChapter 3.2 / Page 15 of 31
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Tools and auxiliary Means
Figure 11
Agfa Company Confidential