AGFA CR Series Service Manual page 201

DD+DIS155.11E
3 Status Indicator on the User Interface Board
The digitizer status is indicated via static
or blinking blue, green and red LEDs.
See table below.
Status Digitizer Status
Indicator
Constant Ready for erasure cycle
blue
Blue Erasure cycle
blinking
Constant Stand-by mode (READY) Ready for scanning.
green
Green Busy
blinking
 Fatal digitizer error
Constant
red
 Service mode active
(e.g. shading
calibration)
 Boot-up
Slow red
blinking
 Digitizer warning or
( 1 / sec.)
error
Fast red No connection to Error
blinking Viewer on PC
( 3 / sec.)
Triple No network connection
blinking to PC
( 3 / sec. +
1 sec. off)
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2013
Electrical and mechanical Codes, Fuses, LEDs
Meaning
When entering the next image plate it will be erased.
Image plate gets erased.
Scan cycle active.
Scanning not possible:
 Service intervention required or
 Service function is called up by the field service engineer which
blocks scanning.
For a list of service functions which block scanning refer to
Service Manual chapter 3.2, Tools and auxiliary Means.
Scanning not possible:
 User has to wait until boot-up is finished or
 User intervention required to continue.
Scanning not possible:
Error Viewer not up-to-date or not started up.
Scanning not possible:
Ping sent from digitizer to NX workstation with IP address
configured in digitizer failed.
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Status
Indicator
Figure 3
Chapter 3.4 / Page 7 of 7
Agfa Company Confidential
515101ag.cdr