AGFA CR Series Service Manual page 172

DD+DIS155.11E
CODE
ARC1301
ARC1302
ARC2100
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2013
Detection of a Barcode Label failed. No recognition of a barcode at all.
Meaning: Start marks of the Barcode Label not found, no data content available
for further processing.
Reason 1: IP not transported into scanner.
Cure 1: Try it again with another cassette.
Reason 2: Ambient Light is too bright.
Cure 2: Protect the digitizer from direct sunlight.
Reason 3: Cleaning Brush is not in park position.
Cure 3: Bring the Cleaning Brush outside into the proper park position.
Reason 4: No Barcode Label is on the IP or Barcode Label is not clean.
Cure 4: Check for a clean Barcode Label on the IP.
Replace the defective IP.
Reason 5: 'PMT with Light Collector' defective.
Cure 5: Replace 'PMT with Light Collector'.
Reason 6: 'Optic Module' defective.
Cure 6: Replace 'Optic Module'.
No Scan Data of the Barcode Label available at all.
Meaning: No data present after Barcode Label scanning procedure.
Reason 1: 'Optic Module' defective.
Cure 1: Replace 'Optic Module'.
'Optic Module' eLabel data are not accessible.
Meaning: The access to data stored on the 'Optic Module' eLabel failed.
Reason 1: The cable to 'Optic Module' is defective or disconnected.
Cure 1: Check cables and connectors in the wiring between 'PMI Board' and
'Optic Module'.
Replace 'Cable PMI Board to Optic Module'.
Reason 2: The 'Optic Module' data storage eLabel contains invalid data or no
data at all.
Cure 2: Replace 'Optic Module'.
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Troubleshooting
Message
Chapter 3.3 / 24 of 46
Agfa Company Confidential