AGFA CR Series Service Manual page 130

DD+DIS155.11E
2.4.2 Digitizer Settings
The menu "Digitizer Settings" allows entering data to modify:
Purpose

The local settings of the digitizer:
o Date and Time
o User interface language (language of the user messages displayed in the

The digitizer network settings.
(1) Select service menu: <Digitizer
Usage
Settings>.
(2) Perform the required settings. See
also NOTE below.
(3) If you want to go back to the
default digitizer settings: Select
<Load default settings>.
(4) Select <Load Digitizer
Network Data from USB> to
read out the data from an adc.cpf
file on the digitizer USB flash drive.
This CPF file:
 Can be created with the CCM
tool* or
 Can be exported from the NX
configuration tool.
*The CCM tool (Configuration and Customization Manager) is by default installed on the NX workstation.
NOTE:

The configuration of the digitizer settings is described in the digitizer Service
Manual, chapter 1, Controls, Connections and Setup Procedures.

Function "Load default settings" is available as of software version ARC_1404
only.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
error viewer on the NX workstation)
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced ReaderChapter 3.2 / Page 14 of 31
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Tools and auxiliary Means
Figure 10
Agfa Company Confidential