Crowsnest Assembly - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 28: Crowsnest Assembly
Part 1
A: On flat level ground, lay out (2337) Crowsnest Back and (2345) Porch Floor End so they face each other.
Using the pilot holes as a guide place 2 (2340) Crowsnest Joists flush to the outside edges of (2337) Crowsnest
Back. Make sure the assembly is square then attach joists to (2337) Crowsnest Back with 2 (S3) #8 x 2-1/2"
Wood Screws and to (2345) Porch Floor End with 2 (S4) #8 x 3" Wood Screws, per joist. (fig. 28.1)
B: Measure 12" from the outside edge of one (2340) Crowsnest Joist and place 1 (2340) Crowsnest Joist at
measured spot. Make sure assembly is square then attach to (2337) Crowsnest Back with 2 (S3) #8 x 2-1/2"
Wood Screws and to (2345) Porch Floor End with 2 (S4) #8 x 3" Wood Screws. (fig. 28.1)
This creates the Crowsnest Bottom Assembly.
Fig. 28.1
Outside View
Wood Parts
3 x Crowsnest Joist 2 x 4 x 8-5/8"
2340
1 x Crowsnest Back 5/4 x 4 x 25-1/2"
2337
1 x Porch Floor End 2 x 4 x 38-1/2"
2345
Flush
2340
12"
2345
S4
6 x
6 x
2337
2340
Hardware
#8 x 2-1/2" Wood Screw
S3
#8 x 3" Wood Screw
S4
71
S3
Flush