Attach Swing End To Swing Beam - KidKraft NEWPORT PLAYSET F29015 Installation And Operating Instructions Manual

Step 4: Attach Swing End to Swing Beam
A: Place (4919) SW Rail Block in the centre between (1826) Front Beam and (1825) Back Beam and attach with
1 (H8) 1/4 x 4-1/4" Hex Bolt (with lock washer, flat washer and t-nut). (fig. 4.1 & 4.2)
Fig. 4.1
B: Attach Swing Beam Assembly to the side of the Swing End Assembly with the overhang (fig. 4.3 & 4.4) using
1 (G5) 5/16 x 4-1/2" Hex Bolt (with lock washer, flat washer and t-nut) in the top hole of Triangle Plate and 1 (G8)
5/16 x 2" Hex Bolt (with 2 flat washers and lock nut) in the bottom hole of Triangle Plate. (fig. 4.4) Make sure
Swing End Assembly flares out at an angle. (fig. 4.3)
Fig. 4.3
Side with
overhang
Wood Parts
1 x SW Rail Block 2 x 4 x 5-3/8"
4919
1825
1826
Fig. 4.4
100
o
Hardware
1 x H8 1/4 x 4-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1 x 5/16 x 4-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
G5
1 x 5/16 x 2" Hex Bolt (5/16" flat washer x2, 5/16" lock nut)
G8
1/4" Lock
Washer
1/4" Flat
Washer
1826
1/4"
T-Nut
G8
5/16" Flat
Washer
17
Fig. 4.2
H8
1825
G5
5/16" Lock
Washer
5/16" Flat
Washer
5/16"
1826
T-Nut
5/16"
Lock Nut
europecustomerservice@kidkraft.com
4919
1825