Manual Initialisation - Danfoss VLT Programming Manual

2 How to Programme
NB!
Resets parameters selected in Personal Menu with default factory setting.
2
Par. 14-22 Operation Mode
RFI Filter
Par. 14-50
Par. 8-30 Protocol
Address
Par. 8-31
Baud Rate
Par. 8-32
Par. 8-35 Minimum Response Delay
Maximum Response Delay
Par. 8-36
Par. 8-37 Maximum Inter-Char Delay
Operating Hours
Par. 15-00
Historic Log: Event
Par. 15-20
Par. 15-30 Alarm Log: Error Code

Manual initialisation

1. Disconnect from mains and wait until the display turns off.
2a. Press [Status] - [Main Menu] - [OK] at the same time while power up for LCP 102, Graphical Display
2b. Press [Menu] while power up for LCP 101, Numerical Display
3. Release the keys after 5 s.
4. The frequency converter is now programmed according to default settings.
This procedure initializes all except: Par. 15-00
NB!
When you carry out manual initialisation, you also reset serial communication, par. 14-50
Removes parameters selected in par. 25-00
NB!
After initialization and power cycling, the display will not show any information until after a couple of minutes.
30
initialises all except:
Over Volt's
to par. 15-05
Historic Log: Time
to par. 15-22
to par. 15-32 Alarm Log: Time
Operating Hours
; par. 15-03
Cascade Controller
MG.11.C9.02 - VLT
®
VLT
Power Up's Over Temp's
; par. 15-04
RFI Filter
.
® is a registered Danfoss trademark
HVAC Drive Programming Guide
Over Volt's
; par. 15-05 .
and fault log settings.