Alarm Log: Error Code; Alarm Log: Value; Alarm Log: Time - Danfoss VLT Programming Manual

3 Parameter Description
3.15.5 15-3* Alarm Log
Parameters in this group are array parameters, where up to 10 fault logs can be viewed. [0] is the most recent logged data, and [9] the oldest. Error
codes, values, and time stamp can be viewed for all logged data.

15-30 Alarm Log: Error Code

Array [10]
Range:
3
0 N/A* [0 - 255 N/A]

15-31 Alarm Log: Value

Array [10]
Range:
0 N/A* [-32767 - 32767 N/A]

15-32 Alarm Log: Time

Array [10]
Range:
0 s* [0 - 2147483647 s]
15-33 Alarm Log: Date and Time
Range:
Application [Application dependant]
dependent*
3.15.6 15-4* Drive Identification
Parameters containing read only information about the hardware and software configuration of the frequency converter.
15-40 FC Type
Range:
0 N/A* [0 - 0 N/A]
15-41 Power Section
Range:
0 N/A* [0 - 0 N/A]
15-42 Voltage
Range:
0 N/A* [0 - 0 N/A]
15-43 Software Version
Range:
0 N/A* [0 - 0 N/A]
160
Function:
View the error code and look up its meaning in the
Function:
View an extra description of the error. This parameter is mostly used in combination with alarm 38
'internal fault'.
Function:
View the time when the logged event occurred. Time is measured in seconds from frequency con-
verter start-up.
Function:
Array parameter; Date & Time 0 - 9: This parameter shows at which time the logged event occurred.
Function:
View the FC type. The read-out is identical to the frequency converter series power field of the type
code definition, characters 1-6.
Function:
View the FC type. The read-out is identical to the frequency converter series power field of the type
code definition, characters 7-10.
Function:
View the FC type. The read-out is identical to the frequency converter series power field of the type
code definition, characters 11-12.
Function:
View the combined SW version (or 'package version') consisting of power SW and control SW.
MG.11.C9.02 - VLT ® is a registered Danfoss trademark
®
VLT HVAC Drive Programming Guide
Troubleshooting
chapter.