Drive Chain Slider; Sprocket And Pinion - Can-Am Rally 200 Operator's Manual

V06H0RY
1. Drive chain
2. Adjuster lock
3. Sprocket hub
4. Chain tensioner
Adjust chain deflection by slowly mov-
ing the vehicle forward so any slack
that may have previously been on the
under part of the chain is now on the
top of the chain. The bottom part of
the chain should be taught during ad-
justment.
The deflection should be between 20
and 30 mm (3/4 and 1-1/8 in).
V06H06Y
Turn the axle forward to increase or
backwards to decrease chain free play.
Tighten the chain tensioner lock bolts
to 42 N•m (31 lbf•ft).
CAUTION: Never operate this vehi-
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
_____________________
118
4 3
2 1
When the adjustment is done, repeat
the above procedure to check the
deflection several times at different
spots on the chain.
Replacement
With the chain installed on vehicle,
measure the distance between a span
of 13 links from pin center to pin cen-
ter. Change drive chain if the distance
exceeds the service limit, see an au-
thorized Can-Am dealer.
V02H01Y
A. 404 mm (15-29/32 in)

Drive Chain Slider

Check the drive chain slider at every
ride.
Replace the drive chain slider when it
is worn.
See an authorized Can-Am dealer for
replacement.

Sprocket and Pinion

Check the sprocket axle and pinion
for distortion, excessive wear or oth-
er damages.
V02H02Y
1. Good
2. Replace
A
1
2