Configuring Static Ip Routes - AudioCodes Mediant 800 User Manual

Gateways & session border controllers

Hide thumbs Also See for Mediant 800:

Table of Contents

CHAPTER 13 Network

Configuring the following static routing rules in the Static Routes table enables OAMP

applications to access peers on subnet 17.17.0.0 through the Default Gateway 192.168.10.1

and Media + Control applications to access peers on subnet 171.79.39.0 through Default

Gateway 200.200.85.10 (which is not the default gateway of the interface).

Configuring Static IP Routes

The Static Routes table lets you configure up to 30 static IP routing rules. Static routes let you

communicate with LAN networks that are not located behind the Default Gateway that is specified

for an IP network interface in the IP Interfaces table, from which the packets are sent. Before

sending an IP packet, the device searches the Static Routes table for an entry that matches the

requested destination host/network. If an entry is found, the device sends the packet to the

gateway that is configured for the static route. If no explicit entry is found, the packet is sent to the

Default Gateway as configured for the IP interface in the IP Interfaces table.

You can view the status of configured static routes in the IP Routing Status table. This table can be

accessed by clicking the Static Routes Status Table link located at the bottom of the Static

Routes table (see

The following procedure describes how to configure static routes through the Web interface. You

can also configure it through ini file [StaticRouteTable] or CLI ( configure network >

To configure static IP routes:

Open the Static Routes table (Setup menu > IP Network tab > Core Entities folder > Static

Click New; the following dialog box appears:

Viewing Static Routes

Mediant 800 Gateway & E-SBC | User's Manual

200.200.85.1

Ethernet Output

192.168.10.1

200.200.85.10

Show Quick Links

Table of Contents