Configuring Nat Translation Per Ip Interface - AudioCodes Mediant 800 User Manual

CHAPTER 13 Network
3. Click Apply.
The feature is applicable only to the Gateway application.

Configuring NAT Translation per IP Interface

The NAT Translation table lets you configure up to 32 network address translation (NAT) rules for
translating source IP addresses into NAT IP addresses (global -public) when the device is located
behind NAT. The device's NAT traversal mechanism replaces the source IP address of SIP
messages sent from a specific VoIP interface (Control and/or Media) in the IP Interfaces table to a
public IP address. This allows, for example, the separation of VoIP traffic between different ITSPs
and topology hiding of internal IP addresses from the "public" network. Each IP network interface
(configured in the IP Interfaces table) can be associated with a NAT rule, translating the source IP
address and port of the outgoing packet into the NAT address (IP address and port range).
The following procedure describes how to configure NAT translation rules through the Web
interface. You can also configure it through ini file [NATTranslation] or CLI (configure network
> nat-translation).
➢
To configure NAT translation rules:
1. Open the NAT Translation table (Setup menu > IP Network tab > Core Entities folder > NAT
Translation).
2. Click New; the following dialog box appears:
3. Configure a NAT translation rule according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 13-7: NAT Translation Table Parameter Descriptions
Parameter
Source
'Index'
index
[NATTranslation_
Index]
Figure 13-2: Configuring Static NAT IP Address
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Mediant 800 Gateway & E-SBC | User's Manual
Description
- 109 -