AudioCodes Mediant 800 User Manual page 219

CHAPTER 15 Media
Content-Type: Application/X-Detect
Type = [event type]
Subtype = [subtype of each event type]
The table below lists the event types and subtypes that can be detected by the device. The text
shown in the table are the strings used in the X-Detect header. The table also provides a summary
of the required configuration.
For SBC calls, event detection is enabled using the IPProfile_SBCHandleXDetect parameter in the
IP Profiles table (see
Event
Type
AMD ■
■
■
■
■
CPT ■
■
■
■
■
■
■
■
FAX CED
modem
PTT ■
■
Configuring IP Profiles).
Table 15-1: Supported X-Detect Event Types
Subtype
Voice (live voice)
Automata (answering
machine)
Silence (no voice)
Unknown
Beep (greeting
message of
answering machine)
SIT-NC
1.
SIT-IC
SIT-VC
2.
SIT-RO
3.
Busy
Reorder
Ringtone
Beep (greeting
message of
■
answering message)
■
■
■
voice-start
voice-end
Mediant 800 Gateway & E-SBC | User's Manual
Description and Required Configuration
Event detection using the AMD feature. For more
information, see Answering Machine Detection
Event detection of tones using the CPT file.
Create a CPT file with the required tone types of the
events that you want to detect.
Install the CPT file on the device.
For SIT detection:
✔
Set the SITDetectorEnable parameter to 1.
✔
Set the UserDefinedToneDetectorEnable
parameter to 1.
Note:
For more information on SIT detection, see
Detection.
To configure beep detection, see
Answering Machine Beep.
Set the IsFaxUsed parameter to any value other than
0.
- or -
Set the IsFaxUsed parameter to 0 and the
FaxTransportMode parameter to any value other than
0.
Note: Applicable only to the Gateway application.
Set the VxxModemTransportType parameter to 3.
Note: Applicable only to the Gateway application.
Set the EnableDSPIPMDetectors parameter to 1.
- 179 -
(AMD).
SIT Event
Detecting