AudioCodes Mediant 800 User Manual page 258

CHAPTER 16 Services
➢
To configure a RADIUS server:
1. Open the RADIUS Servers table (Setup menu > IP Network tab > RADIUS & LDAP folder >
RADIUS Servers).
2. Click New; the following dialog box appears:
3. Configure a RADIUS server according to the parameters described in the table below.
4. Click Apply.
Table 16-7: RADIUS Servers Table Parameter Descriptions
Parameter
'Index'
[RadiusServers_
Index]
'IP Address'
ip-address
[RadiusServers_
IPAddress]
'Authentication
Port'
auth-port
[RadiusServers_
AuthenticationPort]
'Accounting Port'
acc-port
[RadiusServers_
AccountingPort]
'Shared Secret'
shared-secret
[RadiusServers_
SharedSecret]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the IP address of the RADIUS server (in dotted-decimal
notation).
Defines the port of the RADIUS Authentication server for authenticating
the device with the RADIUS server. When set to any value other than
0, the RADIUS server is used by the device for RADIUS-based
management-user login authentication. When set to 0, RADIUS-based
login authentication is not implemented.
The valid value is 0 to any integer. The default is 1645.
Defines the port of the RADIUS Accounting server to where the device
sends accounting data of SIP calls as call detail records (CDR). When
set to any value other than 0, the RADIUS server is used by the device
for RADIUS-based accounting (CDR). When set to 0, RADIUS-based
accounting is not implemented.
The valid value is 0 to any integer. The default is 1646.
Defines the shared secret (password) for authenticating the device with
the RADIUS server. This should be a cryptically strong password. The
shared secret is also used by the RADIUS server to verify the
authentication of the RADIUS messages sent by the device (i.e.,
message integrity).
- 218 -
Mediant 800 Gateway & E-SBC | User's Manual
Description