Data Entry On The Lcd Keypad - Vanderbilt SPC42 Series Installation & Configuration Manual

Keypad user interface
12
SPCK420/421
12.1.3

Data entry on the LCD keypad

94
Vanderbilt
– Fail to communicate
– User panic
– XBUS cable fault
– XBUS communications fault
– XBUS mains fault
– XBUS battery fault
– XBUS power supply fault
– XBUS fuse fault
– XBUS tamper fault
– XBUS antenna fault
– XBUS wireless jamming
– XBUS panic
– XBUS fire
– XBUS medical
– XBUS Power supply link
– XBUS output tamper
– XBUS Low voltage
– Engineer restore Required
– Autoarm
System information

– Soaked zones
– Open zones
– Area state
– Low battery (sensor)
– Sensor lost
– WPA low battery
– WPA lost
– WPA test overdue
– Camera offline
– Fob low battery
– Xbus over current
– Installer name
– Installer phone
– Engineer enable
– Manufacture enable
– Reboot
– Hardware fault
– Aux over current
– Battery low
– Ethernet link
– System name
Entering data and navigating the menus on the LCD keypad is facilitated through
the use of the programming interface. The use of the interface for each type of
operation is detailed below.
Entering numeric values
In Numeric Entry mode, only the numeric digits (0 - 9) can be entered.
Installation & Configuration Manual A6V10276959
01.05.2016