Vanderbilt SPC42 Series Installation & Configuration Manual page 219

17.9.3.2.1
Vanderbilt
To configure a WPA from the browser:
Select Full Engineer mode and select the following options Configuration >

Hardware > Wireless > WPA.
The following items can be checked or configured from this page:
Battery Status

The panel receives the battery status from the WPA in every frame. The battery
status can be either OK or Low.
Battery monitoring requires a WPA fitted with the PCB revision E-PC138612 or
later.
Supervise Status

The Supervise status can be any of the following:
– Fault
The panel has not received a supervision message from the WPA in the
period configured in the Wireless Settings page.
– Disabled
Supervision is not configured.
– OK
Supervision is transmitting normally.
Test Status

The Test Status can be any of the following:
– Overdue
The WPA has not been tested in the period configured in the Wireless
Settings page.
– Disabled
Supervision is not configured.
– OK
The WPA test is ok.
1. Click on the Edit button to edit the WPA configuration.
2. Click on the Delete button to delete a WPA from the system.
Adding a WPA
To add a WPA to the system:
Click the Add button in the main WPA Configuration and Status page.

 The Configure WPA page is displayed for the new WPA.
Installation & Configuration Manual
Engineer programming via the browser
Configuration
17
219
A6V10276959
01.05.2016